Tread logic, not carpet math

These floor liners use a molded deep dish profile with raised side walls to keep liquids and debris on the mat surface instead of migrating onto the factory floor covering. The mats are formed from a rubber compound with a smooth top surface and a textured underside. Front mat size is 27 × 20 in with a thickness of 1 in. Rear liner size is 51 × 14 in, intended to span typical rear footwell widths.

How the channels do the work

The molded grooves act as flow paths that direct water and slush into low areas within the mat, while the perimeter lip helps contain runoff during normal pedal operation and door entry. The rubber construction resists water exposure by material type and does not rely on coatings or sprays. Use is interior floor placement for front driver, front passenger, and rear footwell areas. Fit is universal, with ready to trim edges.

Trim, drop in, clean off

Test placement in the vehicle, then trim along the molded perimeter using shears or a utility knife, removing small amounts at a time to match the floor well shape. For cleaning, remove the mats, rinse with water, and wash with mild soap as needed; allow to air dry before reinstalling.

Product benefits:

• Deep dish profile: Raised edges and molded channels retain liquids and debris on the mat surface.
  
• Universal trim lines: Perimeter can be cut to match common floor well outlines in cars, trucks, and SUVs.
  
• 3-piece coverage layout: Includes two front mats plus one rear liner for typical front and rear footwell zones.
  
• Rubber construction: Resists water exposure for routine cabin contact with moisture and tracked-in debris.
  
• Soap-and-water cleaning: Smooth surface allows rinsing and wiping without special cleaners.

Specifications:

• Material: Rubber compound
  
• Dimensions:
  • Front (each): 27 × 20
  • Rear: 51 × 14 in 
    
• Set Weight: 6 lb
  
• Placement or use area: Interior cabin floor wells (front and rear footwells)